t845526
Hi everybody,


I just assembled 20170827_174815.jpg  my first 3d printer and it is working fine. Since the manual is not very detailed i have 1 wire left. Does anybody know what this is and where to put it?
Quote 0 0
kkgian
It's a thermistor for the heatblock. Notice that in your hot end, there are 2 components screwed in, 1 is the heater to heat up the hot end, the other is the thermistor to measure the temperature. 
If you purchase single extruder, this is a spare. Keep it.
Quote 0 0
t845526
Thank you very much for your reply!
Quote 0 0
jescocom
I have the same part left over and I bought the 2017 Tevo with dual extruders. I am new to this forum and to 3d printing. (this is my first 3D printer)  any help would be appreciated.trhanks, Joe
Quote 0 0

Add a Website Forum to your website.